Commodore CP/M module disassembled and rebuilt

Commodore CP/M module disassembled and rebuilt

The Commodore CP/M cartridge was not only infamous from the beginning, but also gained a sad notoriety. Nevertheless, it is a very sought-after module, which is why I completely disassembled mine and made a replica out of it. So everyone can now build such a module himself.

Rebuild of the IEC64W IEEE-488 card for the Commodore C64

Rebuild of the IEC64W IEEE-488 card for the Commodore C64

This article is about the rebuild of an old IEEE-488 interface card for the Commodore C64 and Commodore C128. This card was very useful if you had e.g. the Commodore SFD-1001 floppy which had only one IEEE-488 connector. But also the old CBM floppy drives could be connected to a C64 or C128. Since such hardware is getting rare and hard to get, I rebuilt the board.

Replica of REX 9628 External Kernel 8 card

Create a new board from pictures of old boards, that was my goal. Unfortunately, there were always only fragments, and this from different versions. Therefore, an exact replica was unfortunately not possible, but the board as such was recreated. This required some steps, but they were worth it.

Replica of the DELA EPROMMER II for the Commodore C64

Replica of the DELA EPROMMER II for the Commodore C64

This time I have rebuilt my old DELA EPROMMER II. This was my second EPROM programmer at that time, with which I wrote a lot of EPROMs. And I found that a replica of this extension is worthwhile, especially since still many want to write the EPROMs directly with the C64.

Anmelden